How to lay resin pavers?

How to lay resin pavers?


We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

Question:

>

Answer: a delicate pose with a two-component adhesive.

They are not afraid of frost, they are non-slip. But the resin pavers are also delicate to lay. Indeed, their installation is done with two-component resin-based glue which dries after only thirty minutes, which leaves little room for maneuver. Before any installation of resin pavers, it is absolutely necessary to have a support - in asphalt or concrete - stable, clean and in good condition. If necessary it will be necessary to pass a primer of fixing to allow then the glue to adhere. Precisely, the two-component glue for resin pavers is prepared in small quantities. It is deposited with a spatula on the paver which must be immediately put in place. The joints of a centimeter are also made progressively, with sand. The installation of resin pavers is undoubtedly the most complicated, it does not give the right to make mistakes. If you are unsure of yourself, it is best to use a paver. You too, send us your brico question


Comments:

  1. Parth

    Valuable information

  2. Malazil

    A woman is like a parachute - she can refuse at any time, so you always need to have a spare!

  3. Conlaoch

    It's not quite what I need. Are there other variants?

  4. Darrock

    I think they are wrong. I propose to discuss it. Write to me in PM, speak.

  5. Liviu

    This excellent idea is just about

  6. Khamisi

    This phrase is simply incomparable :), I really like it)))

  7. Kanos

    Incomparable theme, I really like it :)



Write a message